ECO-VE-PRO control and protection panel Toscano adajusa.es
ECO-VE-PRO control and protection panel Toscano adajusa.es

Control panel and protection 2x32A for recharging electric vehicle automatic rearmament ECO-VE-PRO-2P32T15 - Toscano

€282.81 Tax included

€233.73 tax excl.

Control panel and protection single-phase of 32A, for electric vehicle charging point according to scheme 2 of the ITC-BT-52 standard. Equipped with IGA 32A with automatic recloser, class "A" differential and key lock. Degree of protection IP65.

This frame is equipped with surge protectors, both transient and permanent. Automatic rearmament.

Reference: ECO-VE-PRO-2P32T15
Toscano_version 1 color sin leyenda
Representative image for illustrative purposes, the item supplied will correspond to the specifications indicated.

No queries yet, leave the first!
 

The ECO VE PRO control and protection panels are designed to protect electric vehicle charging stations according to the ITC-BT-52 directive.

The protection panel is equipped with protection against both permanent and transient surges in the electrical network and equipped with automatic rearmament and infinite impedance.

The transient surge protector protects the charging station against alterations in the electrical network due to thunderstorms and lightning strikes, as well as connection and disconnection maneuvers of electrical transformers that supply the network. Permanent protection against voltage rises in the electrical network prevent the operation of the equipment when the input voltage is higher than 275V, according to the EN 50550 standard.

COMBI-PRO equipment continuously monitors the current status, supplying current to the charging station whenever the conditions are optimal for the electricity supply. Thus a momentary alteration in the grid will not interrupt the electricity supply. The COMBI PRO system detects the absence of current by disconnecting the charging station from the network. If the absence of current has been due to the fact that the electrical consumption has been exceeded in the installation and the meter of the house or installation requires a total disconnection maneuver, it is not also necessary to manually disconnect the COMBI PRO, it will only be necessary to disconnect the IGA in the house or main electrical installation, the automatic reconnection system that equips COMBI PRO will be responsible for reconnecting the charging station.

If the disconnection has been due to an overcurrent or short circuit problem at the charging station, the equipment will not automatically re-ignite. It can also be configured as over voltage and low voltage (undervoltage) protection, in this case the equipment will cut the voltage when it drops below 180V and reconnect when it rises above 210V and remains at least 10 seconds.

The switchboard is supplied already pre-wired and with all the elements already assembled.


Summary of technical characteristics:

  • Manufacturer: Toscano
  • Reference: ECO-VE-PRO-2P32T15
  • Amperage: 2x32A
  • Power: 7.36kW
  • Rated voltage: 230Vac (L/N) 50/60Hz
  • Shooting curve: C
  • breaking capacity: 6kA
  • Differential: Class A
  • Leakage current: 30mA
  • Surge trigger voltage: >270Vac
  • Surge response time: according to EN 50550
  • Rearmament time: 10 seconds.
  • Reconnection voltage: <255Vac
  • Subvoltage trigger voltage: <180Vac
  • Response time per subvoltage: 10 seconds
  • Reset time: 10 seconds
  • Maximum transient voltage Uc: 320Vac (L/N)
  • Protection level Up (L/N)(N/PE): <1.5kV
  • Maximum discharge intensity (8/20us): 15kA
  • Transient protection class: Class II
  • Consumption of Vigivolt protections: 0.1VA
  • Maximum terminal section: 25mm²
  • Environmental margins: -5º.. +40ºC / 80º HR
  • Degree of protection: IP65
  • Dimensions (mm): 245x190x155
  • Lock: Lock with metal key.
  • Standard: IEC61643-11 / EN61643-11 / IEC61439-123 / ITC-BT-52 / EN 50539-11:2013/A1:2014 / EN60269-6:2011 / IEC60364-7-712:2017 RLV / EN 60947-3:2009/A2:2015 / EN31439-1:2012 / EN 61439-2:2012/A11:2018


For more information you can download the manual by clicking on the "ATTACHMENTS" tab


Connexion: 

Esquema de montaje ECO-VE-COMBI Toscano Adajusa

To expand the information you can download the technical sheet by clicking on the "Attachments" tab.
Material for professional use, install in compliance with the regulations in force at the place of installation.

Questions

Be the first to ask a question about this product!

Question about the product

* Required fields
(read)

Responsible: ADAJUSA (CONSTRUCCIONES PBR, S.L.), purpose: Respond to requests for information, legitimacy: consent of the interested party, recipients: data will not be communicated to third parties, rights: Access, rectify and delete data, as well as other rights, as explained in the additional information. (read)

16 other products in the same category:

Customers who bought this product also bought:

Product added to wishlist
Product added to compare.