Control panel and protection ECO-VE-PRO Toscano ADAJUSA
Control panel and protection ECO-VE-PRO Toscano ADAJUSA

Protection panel 2x25A for electric vehicle recharging automatic reset ECO-VE-PRO-2P25T15 - Toscano

€277.13 Tax included

€229.03 tax excl.

25A single- single-phase control and protection panel, for recharging point for electric vehicles according to scheme 2 of the ITC-BT-52 standard. Equipped with IGA 25A with automatic recloser, class "A" differential and key lock. Degree of protection IP65.

This panel is equipped with protectors against overvoltages, both transient and permanent. Automatic reset.

Reference: ECO-VE-PRO-2P25T15
Toscano_version 1 color without legend
Representative image for illustrative purposes, the supplied article will correspond to the indicated specifications. 

No queries yet, leave the first!
 

The ECO VE PRO control and protection panels are designed to protect electric vehicle charging stations according to the ITC-BT-52 directive.

The protection panel is equipped with protection against both permanent and transient overvoltages in the electrical network and equipped with automatic reset and infinite impedance.

The protector against transient overvoltages allows the charging station to be protected against alterations in the electrical network due to electrical storms and lightning strikes, as well as connection and disconnection maneuvers of electrical transformers that supply the network. The permanent protection against voltage surges in the electrical network prevents the equipment from operating when the input voltage is greater than 275V, according to the EN 50550 standard.

The COMBI-PRO equipment continuously monitors the state of the current, supplying current to the charging station whenever the conditions are optimal for the electrical supply. Thus a momentary disturbance in the network will not interrupt the power supply. The COMBI PRO system detects the absence of current by disconnecting the charging station from the network. If the absence of current has been due to the fact that the electrical consumption has been exceeded in the installation and the meter of the dwelling or installation requires a total disconnection maneuver, it is not necessary to manually disconnect the COMBI PRO, it will only be necessary to disconnect the IGA in the home or main electrical installation, the automatic reconnection system that COMBI PRO equips will take care of reconnecting the charging station.

If the disconnection was due to an overcurrent or short-circuit problem in the charging station, the equipment will not restart automatically. It can also be configured as overvoltage and low voltage (undervoltage) protection, in this case the equipment will cut off the voltage when it drops below 180V and reconnect when it rises above 210V and lasts for at least 10 seconds.

The distribution board is supplied pre-wired and with all the elements already assembled.


Summary of technical characteristics:

  • Manufacturer: Toscano
  • Reference: ECO-VE-PRO-2P25T15
  • Amperage: 2x25A
  • Power: 5.75kW
  • Rated voltage: 240Vac (L/N) 50/60Hz
  • Trigger curve: C
  • Breaking power: 6kA
  • Differential: Class A
  • Leakage current: 30mA
  • Overvoltage trip voltage: >270Vac
  • Response time due to overvoltage: according to EN 50550 standard
  • Reset time: 10 seconds.
  • Reconnect voltage:
  • Undervoltage trip voltage:
  • Undervoltage response time: 10 seconds
  • Reset time: 10 seconds
  • Maximum transient voltage Uc: 320Vac (L/N)
  • Protection level Up (L/N)(N/PE):
  • Maximum discharge intensity (8/20us): 15kA
  • Transient protection class: Class II
  • Vigivolt protection consumption: 0.1VA
  • Maximum section in terminals: 25mm²
  • Environmental margins: -5º..+40ºC / 80º HR
  • Degree of protection: IP65
  • Dimensions (mm): 245x190x155
  • Lock: Lock with metal key.
  • Standard: IEC61643-11 / EN61643-11 / IEC61439-123 / ITC-BT-52 / EN 50539-11:2013/A1:2014 / EN60269-6:2011 / IEC60364-7-712:2017 RLV / EN 60947-3 :2009/A2:2015 / EN31439-1:2012 / EN 61439-2:2012/A11:2018


For more information you can download the manual by clicking on the "ATTACHMENTS" tab


Connection:

Assembly diagram ECO-VE-COMBI Toscano Adajusa

For more information, you can download the technical sheet by clicking on the "Annexes" tab.
Material for professional use, install in compliance with the regulations in force at the place of installation.

Questions

Be the first to ask a question about this product!

Question about the product

* Required fields
(read)

Responsible: ADAJUSA (CONSTRUCCIONES PBR, S.L.), purpose: Respond to requests for information, legitimacy: consent of the interested party, recipients: data will not be communicated to third parties, rights: Access, rectify and delete data, as well as other rights, as explained in the additional information. (read)

16 other products in the same category:

Product added to wishlist
Product added to compare.